Bosch T20-UL - Manual (Page 10)

10
Installation ć
step by step
1. Unpack the dryer.
2. Remove all objects from the
drum.
3. Check the dryer for visible
damage.
4. Position the dryer near the
installation location.
5. Have the power supply cord
fitted by an authorized
technician (see page 8).
6. Move the dryer to its final
location and align.
CAUTION
Do not slide dryer across the
floor if heightĆadjustable feet
have been extended. Feet and/or
dryer base may be damaged if
dryer is slid across floor with
heightĆadjustable feet extended.
7. Position and then level the
dryer .
The dryer should be level with
all four feet firmly on the
ground. The dryer must not
wobble.
If the dryer is not level or if it
does wobble, the feet must be
adjusted. Adjust the
heightĆadjustable feet until the
dryer does not rock and is level,
both frontĆtoĆback and
sideĆtoĆside.
8. Insert plug into the wall
receptacle.
BuiltĆin Installation
The appliance can be builtĆin;
that is, you can install the dryer
underĆcounter in a kitchen
cabinet opening. The cabinet
opening should be square and
have dimensions as shown in the
figure.
a 600 mm minimum // 23 5 /
8
"
b 600 mm minimum // 23 5 /
8
"
c 850 mm minimum // 33 1 /
2
"
i If installed under a countertop,
the countertop must be
continuous and securely
attached to neighboring
cabinets.
CAUTION
An opening of at least 31 square
inches (200 cm
2 ) must be availĆ
able at the front and side of the
closet.
Check list before
using the dryer
1. Check that steps 1Ć8 have
been implemented properly.
2. Ensure that the dryer is
connected to the power supply.
3. Read the operating instructions
to understand how your dryer
operates.
4. Conduct an appliance test:
q Check that the drum is
empty.
q Close the dryer door.
q Switch the dryer to Extra
Dry" and then press the
Start button.
q After 3Ć5 minutes press the
Stop button and open the
door.
5. If the interior of the dryer feels
warm, the dryer has been
connected properly.
Switch the dryer to OFF".
6. If the dryer does not work,
switch the dryer to OFF".
Look in the troubleshooting
section (page 20) of the
OPERATING INSTRUCTIONS
and find the fault.
Preparing to transport
the dryer ć step
by step
1. Rotate the program selector
to OFF".
2. Pull out power supply plug.
3. Place any accessories in the
drum.
4. Close the door and secure with
adhesive tape.
5. Screw the heightĆadjustable
feet of the dryer into the
housing to prevent them from
being damaged during
transportation.