BAND-IT ID3016 ID Tag Imprinter - Manual

BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925 Document # P71089 rev. A
© Copyright
BAND-IT-IDEX, Inc. 2006
All rights reserved
www.BAND-IT-IDEX.com
Page 1 of 1
ID3016
ID Tag Imprinter
Character Dial
Instructions
Caution: Table is under tension when pushed all the way to the right.
Character Dial Installation – Install before using imprinter for the first time
• Remove table limit screw.
•
Remove escapement wheel screw and washer, place escapement wheel on axle and replace screw
and washer.
•
Slide table onto the tool from the left and slide all the way to the right. Replace table limit screw.
•
Remove screw from center of ram assembly and slide character wheel and dial washer into place.
Replace screw.
Character Dial Replacement
•
Remove screw in center of dial and take dial and knob assembly off. Slide table to extreme right and
remove table limit screw.
•
To safely return table to the left, hold table to the right and push spacer button to allow table to move
slowly to the left and expose spacing mechanism.
•
Remove escapement wheel screw, dial washer and escapement wheel and replace with parts from kit.
•
Move table all the way to the right and reassemble table limit screw.
Dial Kits:
Dial kits come complete with dial
wheel, escapement wheel, and dial washer.
Catalog Number Description
ID3816 1/16” Letter Dial Kit
ID3906 3/32” Letter Dial Kit
ID3826 1/8” Letter Dial Kit
ID3836 3/16” Letter Dial Kit
ID3846
1/4” Letter Dial Kit
Character
Dial Wheel
Escapement Wheel
Dial Washer