BAND-IT M21050 Scru-Seal - Manual

Installation
Instructions M21050
Scru-Seal
Scru-Seal Installation Instructions
SINGLE WRAPPED
1. Insert end of rack into housing and turn screw just
enough to engage rack. Be sure words “THIS SIDE UP”
on rack are facing operator.
2. Bend end of band toward underside to form a 1”-2” hook
and insert in band slot of housing. Wrap the assembly
snugly around object and at a point TWO INCHES
BEYOND first serration, cut, then bend a second 1”-2”
hook toward underside of band.
3. Insert hook into either band slot on both housing and rack
and flatten with thumb, forming clamp. Tighten screw with
screwdriver to desired tension. Clamp is complete.
DOUBLE WRAPPED
Wrapping TWICE around gives greater strength. For
double wrapped, wrap band around object same as step
#2 and insert band again through same housing slot and
wrap band snugly around second time. Measure and cut
same as step #2. Flatten last hook with thumb, check
alignment of the two bands and tighten screw with
screwdriver to desired tension. Clamp is complete.
BAND-IT-IDEX, Inc.
A Unit of IDEX Corporation
4799 Dahlia Street
Denver, CO 80216-3070 USA
P: 1-800-525-0758
F: 1-800-624-3925
www.BAND-IT-IDEX.com
Page 1 of 1
Document # M21050 Rev. -
© Copyright
BAND-IT-IDEX, Inc. 2007
All rights reserved