Bos IDYLLE SC 2014 User manual - Manual (Page 3)

Fitting your Idylle onto your bike demands care and attention.
For your safety, please do respect to the following instructions.
1.1. the steerer tube
Before cutting the steerer tube, first you have to take some measurements : height of the headset, length of the
headtube of the frame, height of the stem and then add 5 to 10mm.
Calculate the lenght as below :
Add the length of the headtube of the frame to the height of the headset and to height of the headset plus 5 to
10mm.
1.2. INSTALLING THE FRONT WHEEL
To assemble the front wheel, check the following procedure
1. Open the two quick releases on each side of the fork (1).
1.3. Disc brake installation
The Idylle SC disc bolt pattern uses caliper mount for post mount 160 (PM160).
To assemble the disc brakes, check the following procedure:
1. Install the DH disc brake system, according to disc brake manufacturer's specifications.
2. Be sure to torque all fasteners and bolts to manufacturer's recommendations. Consult the instructions that
came with your disc brakes for proper installation procedures. It is recommended to install a NEW disc
brake pads, to ensure proper alignment and to minimize drag.
1. ASSEMBLY
CAUTION
Never attempt to remove or replace the steerer or upper tubes independently from the crown. Modifying the
integrated crown, steerer, or upper tubes can cause an assembly failure, resulting in a loss of control of the
bicycle and serious injury.
IMPORTANT
The torque of the QR screws (A) is originally settled between 4 and 4,5 N.m.
It may be usefull to check it regularly.