Bos VOID 2014 User manual - Manual (Page 8)

Cleaning
Clean your shock after each ride using a non-aggressive, non-alkaline cleaning product, let it dry then spray with
silicon spray and protective grease. Check it regularly and remove any dust/dirt from the bottom-out bumper.
Cleaning Oil service Full service
Recreational use
after single ride once a year
Every 2 years
Racing use once a year
4. MAINTENANCE
6. Before screwing back the cylinder, make sure
that the rebound knob and the sticker of the
main cylinder are perfectly aligned (5).
7. Once tighten, make sure that the cylinder (A)
and the top of the air chamber (B) come at the
same level (6). In case not, check if the valve
cylinder is well positionned.
5 6
B
!
A
IMPORTANT
Never attempt to alter the pressure in the shock’s reservoir.
It never needs to be changed and the gas only acts to pressurize the hydraulic fluid in order to avoid cavitation.
Attempting to modify the reservoir pressure will only result in shock failure.
The oil service and full service must be performed by a BOS approved center. The BOS approved centers are
the only able to identify and appraise a damaged or worn part, especially in case of shock or wear on structural
elements such as the legs, the stanchions and the crowns.
IMPORTANT