Bos Dizzy 2014 User manual - Manual (Page 4)

1.3 Installing the 15mm axle
To install the front wheel, follow these instructions:
1. Undo the quick release (1).
2. Unscrew the axle to remove it (2).
3. Position the wheel.
4. Insert the axle and tighten it completely. Close the quick release to lock the wheel.
Removing the wheel is done by reversing the preceding instructions.
1.4. Disk brake installation
The Dizzy uses standard post mount 160 (PM160) mount points.
To assemble the disc brakes, follow this procedure:
1. Install the disc brake caliper according to disc brake manufacturer's specifications.
2. Torque all fasteners and bolts to manufacturer's recommendations. Consult the instructions that came with your disc brakes
for proper installation procedures. It is recommended to install NEW disc brake pads, to ensure proper alignment and to
minimize drag.
3. Route the disc brake hose (for hydraulic disc brakes) or brake cable housing (for mechanical disc brakes) from the caliper to
the inside of the lower leg and through the supplied disc brake hose guide.
4. Tighten the disc brake hose guide screw (M3 x 12) with a 2.5 mm-hex key wrench, and torque it to 1 N.m.
5. Test the brakes for proper operation on level ground before hitting the trails.
The disc brake caliper mounting bolts must have 10 mm of thread engagement with the fork.
Never exceed 10 N.m. of torque when tightening the disc brake caliper mounting bolts.
(1)
(A)
(2)
(1)