Bissell ZING 10M2 - Manual (Page 5)

w w w . b i s s e l l . c o m 8 0 0 . 2 3 7 . 7 6 9 1
A
ssembly
1. Connect hose to vacuum by inserting
hose connector on the end of the hose
into the suction inlet. Make sure the hose
is positioned so the tabs on the hose
connector line up with the notches on the
suction inlet. Once inserted into the
suction inlet, turn clockwise to lock into
place.
2. Attach extension wands section together
by inserting into one another and
twisting slightly to tighten.
3. Connect hose handle to the end of the
extention wand and twist slightly to
tighten.
4. Connect floor nozzle to the end of the
extension wand and twist slightly to
tighten.
5. Once assembled, you can store your
vacuum by inserting the storage clip
(located on the back of the floor nozzle)
into the storage slot on the rear of the
vacuum.
WARNING:
Plastic film can be
dangerous. To avoid danger
of suffocation, keep away
from babies and children.
1.
4.
3.
2.
5.
5
Suction Inlet