C.B.S. Scientific SG Series - Manual (Page 9)

C.B.S. œ Scientific
9
Adjustable Height Sequencer
Section 3
Assembly
3.1
Unit Assembly for Adjustable Height Sequencer
1. Place the Adjustable Sequencer on a level work surface in an authorized work area. Attach
three guide rods to base. Tilt base on its side, place stainless steel screw through
countersunk hole and screw the guide rods onto the base.
2. Secure lower reservoir to base by tightening the two black knurled thumb screws.
3. Once guide rods are secure and apparatus is flat on laboratory bench, slide the upper
reservoir over the three guide rods. To adjust upper reservoir to desired height, align notch
in glass plate with upper reservoir fascia. Tighten the three rosette knobs on the upper
reservoir until secure. Level apparatus using leveling feet in base.
4. Upper and lower reservoirs are shipped with drain plugs installed. Verify that the drain
plugs are secure. If you plan to use accessory Quick-Disconnect fittings (Cat.# QDC-B and
QDC-I), remove the drain plugs. Wrap the end of the Quick Disconnect Insert with Teflon
tape and thread into the drain hole. Be sure the Quick Disconnect Body is secure and the
Quick Disconnect Insert snaps into place.
5. Level the assembled sequencer using the four leveling feet supplied. Each sequencer is
shipped with an attached bubble level.
3.2 Unit Assembly for Dual Adjustable Height Sequencer
1. Place the Dual Adjustable Sequencer on a level work surface in an authorized work area.
Attach two guide rods to base. Tilt base on its side, place stainless steel screw through
countersunk hole and screw the guide rods onto the base.
2. Secure lower reservoirs to base by tightening the four black knurled thumb screws.
3. Once guide rods are secure and apparatus is flat on laboratory bench, slide the divided
upper reservoir over the two guide rods. To adjust upper reservoir to desired height, align
notch in glass plate with upper reservoir fascia. Tighten the two rosette knobs on the upper
reservoir until secure. Level apparatus using leveling feet in base.
4. Upper and lower reservoirs are shipped with drain plugs installed. Verify that the drain
plugs are secure. If you plan to use accessory Quick-Disconnect fittings (Cat.# QDC-B and
QDC-I), remove the drain plugs. Wrap the end of the Quick Disconnect Insert with Teflon
tape and thread into the drain hole. Be sure the Quick Disconnect Body is secure and the
Quick Disconnect Insert snaps into place.
5. Dual units include a rotating base. Align cut-out in bottom of base with rotating base. Use
stationary pin to keep unit form rotating.
6. Level the assembled sequencer using the four leveling feet supplied. Each sequencer is
shipped with an attached bubble level.