Cambridge SoundWorks P500 Subwoofer User Manual

Page 11

Advertising
background image

11

11

11

jack in the Control Module.

To insure you connect the wires properly (positive to

positive, negative to negative), note which of each

speaker wire’s two conductors is “marked”. This mark-

ing may be a ridge in the insulation, different colored

conductors or printing on only one side. Use the

marked side of the speaker wire to connect the posi-

tive speaker terminals. Use the other wire for the nega-

tive terminals.

Using a small flat bladed screwdriver, loosen the four

set screws inside the Speaker Wire Connector plug.

Pull out the short speaker wires.

Following the markings on the Speaker Wire Connector

diagram (for Right positive, Right negative and so on),

insert the correct wires into the plug’s openings.

RIGHT IN

LEFT IN

CENTER IN

PREAMP LEVEL INPUTS

RIGHT

HIGH PASS

OUT

SUB IN

LEFT
HIGH PASS
OUT

+

+

+

RIGHT

CENTER

LEFT

SPEAKER LEVEL INPUTS

1

2

INTERFA

CE JACKS

ON

AUTO

OFF

12V

AC INPUT

Newton, Massachusetts USA

Made in China

CONTROL MODULE

NO USER SER

VICEABLE P

ARTS INSIDE

REFER SER

VICING T

O QUALIFIED PERSONNEL

00000000

Powered

Subwoofer

POWER

INTERFACE J

ACKS

120VAC

7.0A

Tighten each set screw to hold the wires in place.

Connect to the Subwoofer Enclosure:

Once the

input connections are made to the Control Module,

connect the Interface Cable from the Control Module

to the Subwoofer Enclosure.

The interface Cable has plugs that look and connect

like telephone connector plugs. The plugs are the

same at both ends.

Making sure both the Control Module and

subwoofer enclosure are disconnected

from any AC power source.

Note:

The second Interface Cable jack on the sub-

woofer enclosure allows you to connect a Newton

Series second subwoofer enclosure with a sub to sub

Advertising
This manual is related to the following products: