Cambridge SoundWorks P500 Subwoofer - Manual (Page 6)

6
6. Sub In:
Connect the SUB OUT jack from a receiver, integrat-
ed amplifier, preamplifier, or surround decoder to this
jack. Use an audio signal cable with single RCA
plugs on each end.
7. Preamp Level Inputs:
Normally, the Right (R) and Left (L) signal outputs
from a preamp will connect to the to RIGHT IN and
LEFT IN. The CENTER IN would only be used when
three equal-level signals need to be combined.
8. Speaker Level Inputs:
Connect the Right and Left speaker outputs of a
stereo receiver/amplifier to the plug that inserts here.
Connect the Right, Center and Left speaker outputs
of a Dolby Surround receiver in WIDE mode to the
plug.
9. Right And Left High Pass Out:
Use these jacks if you have separate components
(preamplifier and power amplifier) and you want to
prevent the low frequency program material from
reaching your main speakers. Connect these signal
jacks to the Right (R) and Left (L) signal input jacks of
the power amplifier. Use a stereo audio signal cable
with two RCA plugs on each end.
10. Main Outputs:
Connect one of these two jacks to the subwoofer
enclosure using the supplied Interface Cable. Use the
other jack only when you to connect a second Newton
Series subwoofer enclosure.
The Remote Control
The Remote Control adjusts the motorized volume con-
trol. Because the output level of deep bass in a room
can vary substantially from one place to another, it’s
best to adjust the subwoofer’s output from your listen-
ing position.
CONTROL MODULE INPUTS AND OUTPUTS
00000000
Powered
Subwoofer
POWER
INTERFACE JACKS
120VAC
7.0A
VOLUME UP
VOLUME DOWN
SUBWOOFER VOLUME
6
8
9
10
RIGHT IN LEFT IN CENTER IN
PREAMP LEVEL INPUTS
RIGHT
HIGH PASS
OUT
SUB IN
LEFT
HIGH PASS
OUT
+ – + – + –
RIGHT CENTER LEFT
SPEAKER LEVEL INPUTS
1 2
INTERFACE JACKS
ON
AUTO
OFF
12V
AC INPUT
Newton, Massachusetts USA
Made in China
CONTROL MODULE
NO USER SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED PERSONNEL
9
Connect the Interface Cable from the
Control Module to one of these two jacks.
Subwoofer Enclosure Input Panel
Control Module Input Panel
7