CCTV Camera Pros iDVR-E Series Video Surveillance Recorders Product Manual - Manual (Page 34)

33 DIGITAL VIDEO RECORDER
y USE Numeric button to select Motion Grid. GRAY Will be cleared. Or Use <+>
button to select Motion Grid at Front Panel. Running Man Icon will be
activated. <+> button is used for selecting and cancel. Use <-> button to escape
from Grid Menu.
y It is also possible to select smaller motion grids for more precise motion
detection by using CMS.
5. Save changes and exit the menu, press [ENTER] button. Then go “RECORD” Menu.
6. Select “ON” or “OFF” to Enable or Disable motion detection on a per camera, as
shown below.
7. Press the REC button, then Motion recording starts according to configured Recording
Quality, Frame Rate when Motion detected. It will be back to stand-by mode after
motion recording time is end. Camera does not record under normal conditions.
< Note> Motion Duration will be extended if there is another motion detection while
motion recording.
<Note>
There may be cases when the recorder’s built-in motion detection function does
not operate properly due to the condition of the input video signal or other factors.<
<Note>
It is recommended selection of at least 3 motion blocks to get more accurate
motion recording.
Motion Detected zones