COATS Kit 85607965 Lateral Sonar Kit User Manual
Page 2
85607980 00 06/12
2 of 2
© Copyright 2012 Hennessy Industries and COATS
All Rights Reserved
5.
Fasten the lateral sonar bracket to the mounting
plate using supplied countersink screws. Place mount-
ing plate on chassis front and align the hole locations.
Install the storage pegs using a hex key.
6.
Open a slit in the side of the rubber grommet using
a razor blade, knife or scissors. Route cable from the
lateral runout sonar through the grommet and into the
hole of the cabinet as shown. Install the grommet in the
hole opening.
7.
Inside the chassis, connect one end of the audio
cable to this connector and the other end to connector
12 at MCB.
8.
Connect the switch cable onto the main circuit
board (2 pin location).
9.
Perform functional checks to ensure proper instal-
lation.
Lateral Runout Cable
Entering Cabinet
Screw & Washer
Location
Screw & Washer
Location
Install Storage
Pegs
Slit Grommet For Easy
Installation