COATS Kit 85609761 Wall Shadow Board User Manual
Page 3
Balancing Solutions
• 3
Assembly and Installation
Always wear safety goggles to
protect your eyes.
1.
Assemble the Grips onto the Hooks if not already
assembled. (Fig. 2)
2.
Assemble each Hook onto the Shadow Board using
two 3/8-16 UNC Locknuts (Fig. 2 & 3). Hand-tighten the
Locknuts, leaving the threaded portion of the Hook flush
with the Locknut. Make sure the Hooks are pointing
upward toward the COATS logo.
3.
Position the Shadow Board in the desired location.
Mark the four mounting hole locations on the wall, then
for each location drill a 3/8-inch hole 3-1/4 inch deep.
4.
To install, insert a sleeve anchor into each mount-
ing hole and into the wall. Tighten the sleeve anchor to
expand it.
5.
Your Shadow Board is now ready to store your
COATS brand balancing accessories (sold separately).
Figure 3 - Shadow Board Assembly Diagram
Figure 2 - Hook Assembly Diagram
Shadow Board
➋ ➊
➌
➊ ➋
➌
➍
➎
➏
Mounting Hole
➌
Mounting Hole
Mounting Hole
Mounting Hole
➌