COATS 1001 & 1001SC Balancer - Manual (Page 12)

6 • COATS 1001 Wheel Balancer
Direct Drive
1. Start button
2. INNER weight display.
3. INNER position display.
4. OUTER position display.
5. OUTER weight display.
6. STATIC balance button.
7. “MAG” balance button.
8. Wheel diameter (D) knob.
9. Wheel width (W) knob.
10. Wheel offset (A) knob.
Balancing Procedure
Display Board Layout
Leave balancer power on all day.
Static power use is approximately 70 watts.
1. Mount Wheel
Select proper adapter. Adapter selected should center wheel
the same as the wheel is centered on the vehicle.
Almost all wheels, including aftermarket or “mag” wheels,
can be mounted using the standard back-cone mounting kit.
Light truck wheels can be mounted using The standard light
truck cone. Aftermarket wheels with larger than OE center
holes can be mounted using lug adapters.
Wheels that center off the lug pattern, i.e., 68 and older VW,
Peugeot, etc., can be mounted using the optional lug adapter.
The hubnut or lug nut threads must engage four full
turns. Rotate wheel while tightening to ensure cen-
tering. Failure to tighten hubnut securely may result
in serious personal injury.
CAUTION