Direct drive, Error messages and function codes – COATS 850 Solid State Wheel Balancer User Manual
Page 17
COATS 850SS Wheel Balancer • 11
Error Messages and
Function Codes
Error Messages
The following codes may appear in the weight dis-
plays to indicate a problem with the balancer.
A ERR - The distance from the balancer to the inner
rim of the wheel was not entered.
W ERR - The width of the wheel was not entered.
D ERR - The diameter of the wheel was not
entered.
ERR 1 - Wheel moved, but stopped for some
reason.
ERR 2 - Wheel did not come up to speed in 26
seconds.
ERR 3 - Wheel did not turn when the START button
was pushed. Alternatively, no optical
signals.
ERR 4 - Wheel rotates counter-clockwise.
ERR 5 - Cycle did not complete within 26 seconds.
ERR 6 - No power to optical encoder.
ERR 7 - Overspeed.
ERR 8 - Time to set gain is too long.
ERR 9 - Measurement time is too long.
ERR 10 - Measurement speed is too slow.
HOOD - Hood up during wheel motion.
HUB - Wheel reached speed too quickly.
Function Codes
CODE 9 1 A - Perform Calibration
CODE 0 3 A - Clear
CODE 0 4 A - Toggle High Resolution Mode on/off
CODE 0 5 A - Toggle Gram/Ounce Mode on/off
CODE 3 7 A - Adjust top-dead-center position error
Direct Drive