COATS 950 Pro Racer Wheel Balancer - Manual (Page 11)

COATS 950 Pro Racer Wheel Balancer • 5
Pro Racer
Control Panel
Ẅ Keypad — User enters information and selects
function using these keys.
ẅ Wheel Measurement Display — Displays A, W,
and D values.
Ẇ Wheel Offset (A) — The distance between the
inner rim flange and the edge of the balancer. Refer to
Data Entry beginning on page 9 for detailed instruc-
tions.
ẇ Wheel Width (W) — The width of the rim
between the inner and outer rim flanges. Refer to
Data Entry beginning on page 9 for detailed instruc-
tions.
Ẉ Wheel Diameter (D) — The diameter of the
wheel at the weight location. Refer to Data Entry
beginning on page 9 for detailed instructions.
ẉ Calibrate — Places the balancer in the Calibrate
Mode. Press and hold the SHIFT key, and press 1.
Ẋ Round Off — Toggles the balancer between the
high accuracy mode (0.01-ounce increments) and the
normal mode (0.25-ounce increments). Press and hold
the SHIFT key, and press 6.
ẋ Ounce/Gram — Toggles the balancer between
ounces or grams. Press and hold the SHIFT key, and
press 9.
Ẍ Mode — Selects the desired balancing mode.
ẍẻ Balancing Modes — Press the MODE key to
select from the 8 available modes. The LED above the
mode will illuminate to indicate the mode is selected.
ẍẍ Weight Unit LEDs — Indicates that weight read-
ings are shown in ounces or grams (see 12).
ẍẎ Start Button — Press to start a spin cycle.
ẍẏ Weight Displays — Indicate the weight amount
to be attached to the wheel.
ẍẐ Weight Position LEDs — Center LEDs flash
when correct weight position is at top-dead-center.
ẍẑ Rim/Tire Reading Indicators — When lit, the
readings in the displays represent the weight values
for the rim and tire individually. Used only with Match-
Mount.
Ẅ
ẅ
Ẇ ẇ Ẉ
ẉ
Ẋ
ẋ
Ẍ
ẍẻ
ẍẎ
ẍẏ ẍẏ ẍẐ ẍẐ
ẍẑ ẍẑ
ẍẍ