Barco GRAPHICS 1208S R9000893 - Manual (Page 13)

Connections
3-4 5975847 BARCOGRAPHICS 1208S 220197
Connecting a RGB Analog source to port 3.
Connect your RGB source via an interface to Port 3.
Always use an interface when a computer and local monitor have to
be connected to the projector.
Barco interfaces which can be applied :
Universal analog interface
R9826100
RGB 120 MHz analog interface R9826570
VGA interface
120V R9828079
230V R9828070
MAC interface 120V R9828059
230V R9828050
MAGIK interface 120V R9828129 & R9828128
230V R9828120 & R9828121
RGB analog input with automatic sync detection. (Separate H and
V sync inputs, with composite sync input or with sync signals on
green)
Pin configuration D9 connector of the Analog input.
1
not connected
2 ground RGBS
3 RED
4 GREEN
5 BLUE
6 ground RGBS
7 ground RGBS
8 Hor/comp. sync
9 Vert. sync
Analog Input Selection :
with the RCU or build in RCU, press digit button 3.
Connecting a RGB Analog source to port 4/5.
RGB analog input terminals with separate H and V sync inputs, with
composite sync input or with sync signals on green (automatic sync
detection).
Always use an interface when a computer and local monitor have to
be connected to the projector. See 'Connecting a RGB Analog
source to port 3' for a list of BARCO interfaces which can be applied.
RGB input selection :
(RGB : R, G, B signals with automatic sync detection)
with the RCU or the build in RCU : press digit
button 4 or 5
75 ohm
OFF ON
PORT 1
(VIDEO) PORT 4/5
(RGB - HV)
Comp/H sync V sync
R G B
PORT 3 PORT 6 REMOTE
COMMUNICATION
PROJECTOR MODE POWER/MAINS
PORT 2
(S-VIDEO)
75 ohm
ON OFF
GREEN : operational
RED : stand-by
INP INP R G
B H V
INPUT ANALOG INTERF. 120MHz ON
OFF
inver. 75 ohm term.
361
75 ohm
OFF ON
PORT 1
(VIDEO) PORT 4/5
(RGB - HV)
Comp/H sync V sync
R G B
PORT 3 PORT 6 REMOTE
COMMUNICATION
PROJECTOR MODE POWER/MAINS
PORT 2
(S-VIDEO)
75 ohm
ON OFF
GREEN : operational
RED : stand-by
INP INP R G
B H V
INPUT ANALOG INTERF. 120MHz ON
OFF
inver. 75 ohm term.
363