COATS CDH-4730 Electric-Hydraulic Tire Changer - Manual (Page 14)

1
DO NOT keep your hands on the tool when setting it in working position so as to avoid any possible crushing between tire and
tool.
8) Repeat the operations of points (5) and (6) until the second bead is completely detached (fig.21)
9) Go ahead on pushing the tire it comes completery off the rim (fig.22)
Fig.20
Fig.21
Fig.22
1



15
18
7.._Tire mounting with roller tool.
1) Make sure that the rim is clamped properly (see paragraph on “Rim Clamping”).
) lubricate both beads and the rim with tire manufacturer recommended lubricant.
) Attach the g-clamp to the outside edge of the rim. at its highest point.
DANGER!
When the beads come off the rim, the tire will fall. Check to make sure there are no by-standers in the work
area.
CAUTION!
Make sure the g-clamp is firmly attached to the rim.