COATS CDH-9551 Electric-Hydraulic Tire Changer - Manual (Page 10)

10
DANGER!
When the spindle carrier arm is lowered, there is always a potential for crushing anything in its movement
range. Always work from the position given in the instructions keep well out of the working range of the vari-
ous moving arms.
Move the joystick towards the lift (c): the tool carriage and the mobile platform (13, Fig. D) shall move towards the spindle (3, Fig. A);
move the jlever towards the hight (d): the carriage and platform shall move away from the spindle.
2) Move the joystick (11, Fig. C) to all available positions and check for each the related movement that must correspond to what
described in chap. 10, “Controls description”.
3) Move switch lever (5, Fig. C) towards the top: the chuck arms (3, Fig. A) should open; move the lever down and the spindle arms
should close.
3) Depress the right pedal (10, Fig. C): the spindle (3, Fig. A) should turn clockwise; depress the left pedal: the spindle should turn coun-
terclockwise.
DANGER!
When the spindle arms open or closed, there is always a potential for crushing anything in their move-
ment range. Always work from the position given in the instructions keep well out of the spindle’s working
range.
D
C
E/1
a
b
c d
e
f
g h
10
9
5
8
11
18
1
1
19
17
15
4) Check to be certain the hydraulic circuit is working correctly:
- move switch lever (5, Fig. C) towards the top until the spindle arms are fully extended.
- hold the switch lever in this position (top) and check if the pressure shown on the gauge on the swivel fitting is 1,885 PSI (130 bar ± 10%).
If the pressure shown in not as indicated here, DO NOT USE the tire changer and call your nearest Service Center.