COATS Kit 8184045, Robo Arm - Manual (Page 3)

9. Next, unwrap the red hose from valve, guide
through hose clamps; and, with the hose pushed
over the barbed fitting, tighten the screw type hose
clamp.
Next, reconnect the air pressure source and check
for leaks. Cycle the cylinder on the Robo-Arm™ sev-
eral times to understand function.
10. For installing bead roller assist tool, attach the
rectangular tube in the kit to the “Bead Loosener
Arm”. Use the existing hole in the bead loosener
arm. Position the tube at a slight angle and tighten.
11. Next will be the installation of the duckhead
bracket. Start by removing the bolt in the bottom of
the vertical slide bar. This bolt is very tight; use cau-
tion when loosening.
12. Next install the bracket to the vertical slide
using the hex bolt; discard the washer. Note that the
metal duckhead is shown; the plastic duckhead can
be substituted for the metal duckhead.
Robo-Arm™
Robo-Arm™ Installation • 3
Figure 9
Figure 10
Figure 11
Figure 12
Bracket