COATS Kit 8184572, PAX Adapter - Manual (Page 2)

8184575 00 11/04 2 of 2 © COPYRIGHT 2004 PRINTED IN U.S.A.
11. Loosely install the PAX adapter support column
to the chassis below the storage tray using 6 (M10x25)
bolts and 6 nuts (fig. 6).
Figure 6 - Install Support Bolts Below The Storage Tray
12. Now tighten all the bolts in a star pattern adjust-
ing tower alignment.
13. Thread the air line from the support column into
the hole on the backside of the chassis and then con-
nect to the air manifold (fig. 7).
Figure 7 - Connect Support Air Line to Air Manifold
14. Remount the infla-
tion gauge — attach chan-
nel to column, attach
gauge to channel, and
attach hose clamp with
hole (fig. 8).
Figure 8 - Remounted Inflation Gauge
15. Replace the side cover.
16. Bolt upper and lower arms using 10mm socket.
Configuring Machine For PAX Tire Service
Important: Always read and follow the oper-
ating manual instructions prior too servicing
your first tire. This will help prevent damage
to the tire and wheel.
17. Place the wheel riser on the table top and clamp.
Figure 9 - Riser Placed on the Table Top
18. Install the tool holder in the upper left arm and
then install the double roller system in the tool holder
with the small roller down.
Figure 10 - Install Tool Holder Then Double Roller
20. Install the tool holder in the lower left arm and
then the tapered roller.
Figure 12 - Tapered Roller installed in the Lower Left Arm Tool
Holder
CAUTION
Ẅ
ẇ Ẉ
ẉ
ẅ
Ẇ