Reduction instructions – COATS Kit 8185531, Clamp Extension/Reduction User Manual
Page 2
Advertising
Reduction Instructions
Use an 8mm hexagonal wrench to
loosen the clamp screw.
Turn the clamp by 180 degrees.
Use the 8mm hexagonal wrench
to tighten the screw.
Turn the whole clamp support on
the turntable by 180 degrees.
Set the support on the clamp.
Set the pin and lock it by the rub-
ber fastening cable.
Repeat the same procedure for
the other clamps.
8185589 00 10/05 2 of 2
© COPYRIGHT 2005 HENNESSY INDUSTRIES AND COATS ALL RIGHTS RESERVED PRINTED IN U.S.A.
Advertising