COATS Kit 85009937 Robo-Arm - Manual (Page 4)

4 • Tire Changers
11. Grease the steel ball and place it in the bottom
of the helper tool.
Figure 11 - Place greased ball in bottom of helper tool.
12. Install the helper tool on the cylinder shaft using
the roll pin.
Figure 12 - Install the helper tool on the cylinder shaft.
13. Connect 1/8-inch nylon tubes from robo cylinder
to cylinder arm valve fittings, as shown in figure 13.d
Figure 13 - Connect nylon tubes.
14. Next, unwrap the hose from valve, guide through
hose clamps; and, with the hose pushed over the
barbed fitting, tighten hose clamps.
Figure 14 - Route hose and tighten hose clamps.
15. For installing bead roller assist tool, attach the
rectangular tube in the kit to the “Bead Loosener Arm”.
Use the existing hole in the bead loosener arm. Position
the tube at a slight angle and tighten.
Figure 15 - Attach tube for bead roller assist tool storage.
1/8-inch
Tubes
Attached
At Valve
Fitting
Attach Using
Roll Pin