COATS Kit 85606545, Kit 85606739 Bead Sealer Accessory - Manual (Page 3)

COATS • 3
Installation for ProGuard™ Tire Changers
1. Disconnect tire changer from power source and
from its air supply. Bleed off all air pressure. Verify the
stored air pressure is zero by observing the air pressure
gauge.
2. Install tank support plate on back of the ProGuard
chassis. When attaching support plate, be sure to
remove and discard the two existing screws from the
chassis and use the two longer screws provided.
3. Next, attach air tank to the tank support plate
using provided screws and washers.
4. Assemble fittings at top of air tank (D) as shown
in parts diagram. Apply thread sealant to all joints.
5. Locate and cut in half the tube (E) from the filter
assembly, install the union tee (T) and hose (G), as
shown in diagram.
6. Thread 3/4-inch staight fitting on hose assembly
(H) into elbow at bottom of air tank.
7. Install hanger. Drill two holes (drill size #1 ø.228)
about 2-inches apart in tool tray. Remove two hooks
and screws from hanger assembly. Attach hooks to
tool tray.
8. Next, reconnect the air pressure source and check
for air leakage at fittings.
Bead Sealer Accessory Operation
1. To perform a bead sealing operation, attach the
inflation hose air chuck to the valve stem of the tire and
wheel assembly.
2. Hold the nozzle against the outer rim lip of the
wheel, aiming it between the rim and tire bead as
shown.
3. Depress the foot pedal to initiate tire inflation
through the valve stem. At the same time push for-
ward on the handle momentarily expanding the tire to
mate the tire bead and rim to complete the bead seal-
ing process.
Place the nozzle against the outer rim lip.
Air Chuck
E
D
H
G
T