COATS Kit 8560761701 Robo-Arm LR User Manual

Page 3

Advertising
background image

Tire Changers

• 3

6.

Locate arm with valve assembly, install the 10 1/2-

inch (267 mm) long bolt with head through the bottom

side, slide pivot pin over bolt and attach nut with only

one turn.

Figure 6 - Locate and position arm with cylinder.

7.

Slide the cylinder arm pivot pin through the swing

arm bushing, hold in position, remove nut and place

washer over bolt threads and assemble nut to bolt.

Figure 7 - Hold swing arm in position to install nut to bolt

8.

Next, using large wrenches, tighten the assembly

to 240 ft. pound torque (very tight). Again, even though

the bolt is very tight, the assembly should be free to

rotate.

Figure 8 - Tighten the swing arm bolt.

9.

Slide the cylinder through the cylinder arm bush-

ing, aligning the cylinder for set screw installation.

Tighten the set screw.

Figure 9 - Slide cylinder through cylinder arm bushing.

10.

Install the external snap ring.

Figure 10 - Install external snap ring.

Set

Screw

Advertising