COATS Kit 85608609, Wheel Lift Accessory - Manual (Page 3)

COATS • 3
4. Remove pedal bracket guard and reserve the bolts.
5. Remove the machine’s side panel using a speed
handle or drill and 3/8-inch socket.
6. Locate and cut in half the 3/8-inch hose that con-
nects the oil injector to the first pedal valve.
7. Find the tee fitting, on the new pedal bracket
assembly, and route it through the front opening to the
inside of the chassis.
8. Install the tee fitting, from the new pedal bracket
assembly, into the just cut 3/8-inch hose and secure
using hose clamps.
9. Use three of the four reserved bolts to fasten the
new pedal bracket assembly to the front of the machine
chassis. Note the pedal valve’s position makes it so the
fourth both cannot be fastened.
Remove Pedal
Bracket Guard
Cut 3/8-inch
Hose
Tee Fitting
Route Hose with Tee
Fitting Inside Chassis
Hose To First
Pedal Valve
Hose From
Oil Injector
Remove Side
Panel
Install Tee
Fitting
Fasten Pedal Bracket
Assembly To Chassis Front