Comark EV SOFTWARE - Manual (Page 13)

12
6.0 Logging Modes
6.1 Manual Start/Stop Modes EV and EVt
When a logger has been set for manual start then the logger display (if fitted) will show
the word MAN in the lower portion of the LCD. In this case the user must press and hold
the navigation button on the front of the logger for 6 seconds to start logging. If manual
stop is also selected then the logger will require the same key operation in order to stop
logging.
6.1.1 Delayed Start (EVt Only)
If a delayed start has been programmed then the logger will display ‘dLAY’ to
indicate that it is counting down to the start time once the navigation button
has been pressed to initiate the programmed task.
6.2 Automatic Start/Stop Modes EV and EVt
In the event that either the start and stop are pre-programmed or that automatic end
is programmed then no further input from the user is required. Simply place the logger
where it is required to log temperature and leave it.
7.0 Retrieving Data from EV loggers
When downloading is required the logger must be be activated, using the navigation button
on the front of the logger, and placed in the interface (face down for EV loggers and face up
for EVt loggers). To stop a logger in manual mode press and hold the navigation button for
six seconds. The word LOG will disappear from the LCD (where fitted on the logger) and the
logger will play a series of beeps. In automatic mode the logger will stop automatically at the
programmed time.
If Auto docking is active the software will automatically detect the logger and begin the
download process, see below:
When the data has been downloaded the software will automatically filter the task database, if
displayed, for the current logger type, its serial number and the current task programmed to it,
and it will automatically draw the graph with the settings as in the
current task.