Comelit FT CB 07 - Manual (Page 26)

GROUP S.P.A.
FT CB 07 24
5I) PROGRAMMING THE ADDRESSES OF INTERNAL UNITS
INITIAL CONDITION
Select the USER CODE
SETTING menu
Enter the address with
which you want to
programme the internal unit
using the
▼▲ keys
EXAMPLE: 0001
Once the code entered
is confirmed with
the key,
press to
exit
Module supplied
with terminal PR
connected to terminal – ,
and internal unit under
programming The module is under
programming:
to select the menu
▼▲ to scroll the menus
to return to the
previous menu
The value of the address
must be a number between
0001 and 9989.
ON DISPLAY DESCRIPTION OPERATION
SYSTEM PARAMETERS
SELECT LANGUAGE
USER CODE SETTING
USER CODE SETTING
0000
USER CODE SETTING
0001
USER CODE SETTING
VIDEO PSU SETTING
* If the system is set with 6 digits it will be necessary to enter the number of the
block of flats before the user code EXAMPLE: 01 0001 (the block of flat numbers
must have 2 digits as in the EXAMPLE).
* If the module is set with 6 digits, the range of addresses will refer to the
addresses of the blocks of flats. The parameter values can therefore vary from a
minimum of 01 to a maximum of 98.
5J) PROGRAMMING THE RANGE OF ADDRESSES FOR THE POWER SUPPLY 4586
INITIAL CONDITION
Select the VIDEO PSU
SETTING menu
Enter the RANGE START
using the
▼▲ keys
EXAMPLE: 0023 *
confirm with the
key
Enter the RANGE END
using the
▼▲ keys
EXAMPLE: 0046 *
confirm with the
key
Once the range of
addresses is set, to exit
press the
key
Module supplied with
terminal PR connected to
terminal – , and power
supply 4586 under
programming The module is under
programming:
to select the menu
▼▲ to scroll the menus
to return to the
previous menu
The value of the address
must be a number between
0001 and 9989
ON DISPLAY DESCRIPTION OPERATION
SYSTEM PARAMETERS
SELECT LANGUAGE
USER CODE SETTING
VIDEO PSU SETTING
RANGE START 001
VIDEO PSU SETTING
RANGE START 0023
VIDEO PSU SETTING
RANGE START 0023
RANGE END 0046
0