Condux Hand Held Micro Fiber Optic Blower User Manual
Page 6
Advertising
6
5. Choose the correct Venturi to fit the cable being installed. Do not install at
this time!
6. Place
the
Seal Disk in Venturi Slot (See Figure 5).
7. Place conduit in the Conduit Seal and Conduit Clamp. Note placement up to
ridge on Conduit Seal (See Figure 6).
8. Close Handheld Blower and secure (See Figure 7). Tighten speedball handle
securely, but do not over tighten.
9. Plug receiving end of Conduit with a properly sized Conduit Pulling Eye (See
Figure 8).
Figure 5 Insert seal disk
Figure 6 Insert duct
Figure 7 Close and tighten handle
Figure 8 Insert innerduct eye
Advertising