Condux Hand Held Micro Fiber Optic Blower User Manual
Page 7
7
10. Connect the Air Compressor
a. Ensure Air Valve is off before connecting air hose.
b. Attach the hose supplied with the air compressor to the air compressor
coupling. The Handheld blower is equipped with a claw type connector.
Use a safety clip on all pneumatic hose connections. (See Figure 9).
c. Observe all safety procedures.
d. Route all hoses properly to prevent tripping over them.
!WARNING: Forced air creates flying debris. Always wear personnel
protective equipment. Severe personnel injury could result.
!WARNING: Ensure no personnel are in the destination access vault
during the blowing operation. Severe personal injury could result.
11. Slowly open Air Control Valve by turning it to the 6 o’clock postion.
Pressurize conduit to 80 – 100 psi (5.5-6.9 bar) (See Figure 10).
Figure 9 Attach air hose
Figure 10 Slowly open air control valve