Control Company 4371 LOLLIPOP WATERPROOF/SHOCKPROOF THERMOMETER - Manual

SPECIFICATIONS
Range:
–50 to 300°C,
–58 to 572°F
Resolution: 0.1°C from –20 to 200°C,
1°C outside this range
Accuracy: Cat. No. 4371:
±1.0°C between
0 and 100°C
Cat. No. 4378:
±0.4°C at tested points
ULTRA™ THERMOMETER ACCURACY
Ultra™ thermometers are tested at se-
lected test points to be within tighter than
normal tolerances to assist in providing
improved accuracy. Other points will not
necessarily fall within accuracy as those
found at selected test points, but will be
within an accuracy of ±1.0°C.
FEATURES
• Waterproof and shockproof
• Stainless steel sensor probe
• Max/Min memory recall
• °F/°C selectable
• One second sampling rate
• Protective plastic sleeve
with clip and holder
• Low battery indicator
OPERATION
Remove Lollipop™ thermometer from the
protective sheath. Press ON/OFF button
to activate. Press °F/°C button to switch
between Fahrenheit and Celsius tempera-
ture. Insert probe into the material to be
measured and read display.
MAX/MIN MEMORY
To view the minimum temperature reached
since activating unit, press MAX/MIN
button. “MIN” appears on the display to in-
dicate the minimum temperature recorded.
Press MAX/MIN button a second time
within 3 seconds to view the maximum
temperature reached since activating unit.
“MAX” appears on the display to indicate
the maximum temperature recorded.
NOTE:
Three seconds after pressing the
MAX/MIN button, the unit auto-
matically returns to current sam-
pling mode. Indicators “MIN” and
“MAX” are no longer displayed.
Turn the unit OFF to reset max/min
to current temperature.
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function
properly for any reason, please replace
the battery with a new high quality battery
(see “Battery Replacement” section). Low
battery power can occasionally cause
any number of “apparent” operational dif-
ficulties. Replacing the battery with a new
fresh battery will solve most difficulties.
BATTERY REPLACEMENT
The Lollipop™ thermometer displays a
low battery indication, “
”, when it is
time to replace the battery.
Erratic readings, faint readings or no
display are all indications that the battery
must be replaced. Using a screwdriver,
unscrew the three screws located on the
battery cover on back of the unit. Remove
the exhausted battery and replace with
a new battery. Make certain the positive
(+) side is facing you. Equivalent battery
replacements are: RAYOVAC RW42,
DURACELL D357, and EVEREADY 357.
Replace the battery cover. Screw the
three screws back into the unit. Do not
over-tighten the screws as this may cause
damage to the battery cover.
TRACEABLE® LOLLIPOP™ WATERPROOF/SHOCKPROOF
THERMOMETER INSTRUCTIONS
WARRANTY, SERVICE, OR RECALIBRATION
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 Fax 281 482-9448
E-mail [email protected]
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and ISO 17025 accredited as a Calibration Laboratory by A2LA.
Cat. No. 4371 / 4378
Traceable ® Lollipop Waterproof/ Shockproof Thermometer Instructions
92-4371-00
Rev. 5 102412
Traceable ® is a registered trademark of Control Company
© 2012 CONTROL COMPANY