CounterPath Bria iPhone Edition 1.3.4/1.3.5 User Guide - Manual (Page 41)

Bria iPhone Edition User Guide
37
Account Advanced (SIP)
To change these fields on an existing account, you must first unregister the account or turn Enabled off for the
account.
Top of Screen Middle of Screen Bottom of the Screen
Field Description
Out. Proxy If your VoIP service provider has an outbound proxy and requires that you provide that address to
Bria, enter the domain name or the IP address obtained from your provider.
Auth Name May not be required. But if it is required, it will be provided by your VoIP service provider.
Send DTMF using The method used for DTMF, sent when you press a number key when dealing with an auto
attendant (such as “press 1 for customer service
” ). In-band DTMF can be sent in addition to the
other two methods.
Choose a method specified by your VoIP service provider.
Global IP • ON: Bria will publish its public IP address at the signaling level. The public address may not
work with some NATs or firewalls.
• OFF: Bria will publish its private IPs at the signaling level. Typically, you turn this field off
only if instructed to do so by your system administrator.
Global IP 3G This setting has the same function as Global IP, but applies only when you are connected over 3G.
If you set this setting to ON, you must also set Global IP to ON.
Use Tel URI Change this value only if advised to do so by your VoIP service provider.
• ON: Prefix SIP URIs with tel://
• OFF (default): Prefix SIP URIs with sip://
SIP Transport Tap to display the choices. Contact your VoIP service provider to identify the types of transport
that are supported.
• UDP and TCP do not support signal encryption.
• TLS does support signal encryption. If TLS is selected, a given call will be encrypted if the
other person also uses TLS. You may also need to install a certificate on your iPhone; speak to
your VoIP service provider.