Daisy PowerLine TargetPro 953 - Manual (Page 4)

4
CAUTION:
The TargetPro 953 is a single pump pneumatic. DO NOT pump more than once! If
gun is left pumped for an extended period of time it could result in damage to this gun.
Step 4. LOAD
TO LOAD A PELLET AS A SINGLE SHOT:
If the single-shot adapter is not already in place
in the receiver, insert it into the clip track from
the right-hand side until it is flush with both
sides of the receiver. Hold the gun with the
barrel in a horizontal position and place a pellet
(head or solid end forward) in the loading track
that is formed by the single-shot adapter. (See
Drawing No. 5).
NOTE: The single-shot adapter can only be
removed from the receiver by pulling it from the
right-hand side of the gun.
TO LOAD 5-SHOT CLIP: With solid end
forward, insert pellet into clip as shown. (See
Drawing No. 6). Be certain that rear edge of
pellet skirt is seated deeply enough to be
beyond the ramp at the lower edge of the pellet
opening. Repeat until clip is completely filled.
TO LOAD 5-SHOT CLIP INTO THE CLIP
TRACK: From the right-hand side of the gun,
insert a previously loaded clip into the clip track
until the left end of the clip is flush with the left
side of the receiver (See Drawing No. 7).
NOTE: The clip may be removed from either
side of the gun.
SINGLE SHOT ADAPTER
PELLET (SOLID
END FORWARD)
BOLT TIP
NO. 5
NO. 6
CLIP TRACK
5-SHOT
CLIP
NO. 7