Black & Decker BDBN1200 - Manual (Page 8)

8
Operating Instructions
Using the Lock-Off (Figure 1)
The nailer is equipped with a lock-off switch which prevents the
tool from actuating. To engage, push the lock-off to the full
rearward position as shown in figure 1.
Loading the Tool (Figure 2)
CAUTION: Keep tool pointed in a safe direction when loading
nails.
CAUTION: Never load nails with the contact trip or trigger
activated.
CAUTION: Always engage lock off and remove battery
pack before loading or unloading nails.
To load fasteners:
1. Read all “Safety Warnings” before using tool.
2. Engage lock off.
3. Remove battery.
4. Depress pusher release and pull magazine back.
5. Insert fasteners into the side of the magazine. Be sure the
fasteners ride on their tips in the nail channel as shown in
figure 2A.
6. Push magazine closed until it locks in place.
Actuating Tool
WARNING: Always wear eye and ear protection when operating tool.
To operate the nailer:
1. Disengage lock off.
2. Insert battery pack and lock in place.
3. Depress the contact trip firmly against the work surface.
4. Depress and maintain pressure on the trigger.
CAUTION: A nail will fire each time the trigger is
depressed as long as the contact trip remains depressed.
Adjusting Depth (Figure 3)
The depth that the fastener is driven can be adjusted using
the depth adjustment buttons on the side of the tool.
WARNING: To reduce risk of serious injury from
accidental actuation when attempting to adjust depth,
ALWAYS:
• Engage lock off.
• Disconnect battery.
• Avoid contact with trigger during adjustments.
1
2
2A
3
625779-00 BDBN1200Booklet 8/9/04 9:55 AM Page 8