Dascom T2250 User Guide IGP for Dot Matrix Printers - Manual (Page 64)

IGP for Dot Matrix Printers User Guide
64
Genicom ANSI Emulation
The Genicom ANSI emulation is defined by the Genicom 4810 / 4840 Programmer’s Manual,
GEK-89025. This emulation supports many standard ANSI escape sequences as well as
extended commands for bar codes and oversize characters.
The following escape sequences are supported:
Command Description Command Description
ESC c Reset Printer ESC \ Exit Special Modes
ESC K Move Partial Line
Down ESC L Move Partial Line Up
ESC [p1 a Move Relative
Horizontal Position
Right ESC [p1 d Move Absolute
Vertical Position
ESC [p1 e Move Relative Vertical
Position Down ESC [p1;p2 f Move Absolute
Horizontal and
Vertical Positions
ESC [p1 j Move Relative
Horizontal Position
Left ESC [p1 k Move Relative Vertical
Position Up
ESC [p1 ‘ Move Absolute
Horizontal Position ESC H Set Horizontal Tab at
Current Position
ESC J Set Vertical Tab at
Current Position ESC [p1;p... g Set and Clear
Horizontal and
Vertical Tabs
ESC [p1;p2;p3 r Set Form Length, Top
Margin, and Bottom
Margin ESC [0 g Clear Horizontal Tab
at Current Position
ESC [p1;p2 s Set Left and Right
Margins ESC [1 g Clear Vertical Tab at
Current Position
ESC [p1;p... u Set Horizontal Tabs ESC [3 g Clear Horizontal Tabs
ESC [p1;p... v Set Vertical Tabs ESC [4 g Clear Vertical Tabs
ESC [p1;p2 SP B Modify Character Size ESC [p1;p2 SP G Set LPI and CPI
ESC [p1;p... m Set Font Style and
Enhancements ESC [p1 x Select Character Set
ESC [0 m Cancel Font
Enhancements ESC [p1;p... h Set Mode
ESC [1 m Enable Bold ESC [11 h Set Position Unit
Mode
ESC [4 m Enable Underline ESC [20 h Set Line Feed New
Line Mode