Chapter 4: miscellaneous, Driver, Cutting device – Dascom T2250 User Guide IGP for Dot Matrix Printers User Manual
Page 77: Standard documentation
Chapter 4: Miscellaneous
77
Chapter 4: Miscellaneous
Driver
This printer model is provided without driver. The IGP printer model basically is delivered with the
standard Online CD-Rom.
The Driver located on this CD rom requires MTPL and Epson LQ emulations. These emulations
are not included in the firmware of an IGP printer model.
NOTE: However the Plug&Play string is identical to that of the standard
printer this means that the standard driver would be installed by
accident. This driver is not functional!
Cutting Device
Basically the optional cutting device will work.
As in IGP the form is defined by the “Create” command, and printing is normally done by the
“Execute” command without a formfeed, the form will not be cut using the “Cut on Formfeed”
setting. Instead it is recommended to use the “Cut on Tof” setting (See printer's menu: ViewCut).
NOTE: The function "cutting" is not determined as there is no support
from the emulations. Hence we recommend to test the proper
function of the cutter in the particular environment.
Standard Documentation
The IGP printer model is provided with its standard printer documentation.
It is intended to being used to describe the basic functions of your printer. Only the special IGP
functions which differ from the standard are described in this manual.