Despatch Protocol Plus Controller (Heat Only) User Manual
Ultraflex drying and firing furnace, Owner’s manual, Plus
Advertising
Table of contents
Document Outline
- 1. About This Manual
- 2. Safety
- 3. Theory of Operation
- 4. Assembly & Setup
- 5. Working with Operating Modes
- 5.1. Start-up Basics
- 5.2. Manual Mode
- 5.3. Timer Mode
- 5.4. Profile Mode
- 5.5. Auto Start Mode
- 5.6. Setup Mode
- 5.6.1. Enter and Exit Setup Mode
- 5.6.2. Temperature Scale Conversion
- 5.6.3. Program Page
- 5.6.3.1. Using the Program Page
- 5.6.3.2. Programming Optional Relay Outputs
- 5.6.4. Sample Profile
- 5.6.5. Setting Up Auto Start
- 5.6.5.1. Configure Auto Start
- 5.6.5.2. Activate Auto Start
- 5.6.5.3. Deactivate Auto Start
- 5.6.6. Setting Up PID Page
- 5.6.6.1. Access the PID Page
- 5.6.6.2. Setting up Auto Tune
- 5.6.7. Setting up the Control Page
- 5.6.7.1. Access Control Page
- 5.6.8. Setting up the Communication Page
- 5.6.8.1. Access Communication Page
- 5.6.8.2. Setting up the Real Time Clock Page
- 5.6.8.3. Access Real Time Clock Page
- 5.6.9. Setting up the Relay Outputs Page
- 5.6.9.1. Access Relay Outputs Page
- 5.6.10. Setting up the Test Page
- 5.6.10.1. Access Relay Outputs Page
- 5.6.10.2. Setting up the Zone Calibration Page
- 5.6.10.3. Access Zone Calibration Page
- 5.6.10.4. Access Factory Calibration Recovery
- 5.6.10.5. Adjusting Actual Versus Displayed Parameters
- 5.6.10.6. Setting up the Sensor Calibration Page
- 5.6.10.7. Access Sensor Calibration Page
- 5.6.11. Setting up the Enable Page
- 5.6.11.1. Access Enable Page
- 5.6.12. Setting up Digital Inputs (Optional)
- 6. Maintenance
- 7. Troubleshooting: Error Messages and Alarm
- 8. Appendices
- 8.1. Quick Reference and Default Values
- 8.1.1. Program Page Default Values
- 8.1.2. Autostart Page Default Values
- 8.1.3. PID Page Default Values
- 8.1.4. Programming Table Worksheet
- 8.1.5. Control Page Default Values
- 8.1.6. Communication (Optional) Page Default Values
- 8.1.7. Real Time Clock Page Default Values
- 8.1.8. Relay Outputs (Optional) Page Default Values
- 8.1.9. Test Page Default Values
- 8.1.10. Zone Cal Page Default Values
- 8.1.11. Sensor Cal Page Default Values
- 8.1.12. Enable Page Default Values
- 8.2. Standard Products Warranty
- /