Bosch Divar -Digital Versatile Recorder User Manual
Page 50
Bosch Security Systems
Divar | Installation Manual | Menu system
EN | 5-8
Adjust contrast
•
Select a camera in the menu or press a camera key on the unit. The
selected camera image appears.
•
Vary the manual gain value between -100 and +100 to adjust the
contrast.
•
To set the default value (0), press the F1 key.
>>> Camera controllable
•
A check mark under a camera number indicates that it can be
controlled remotely by the Control Center application.
•
Press a camera key on the unit to make a camera controllable or
not.
•
By default all cameras are controllable.
>>> Bilinx cameras
•
Only shown if your Divar is a Divar Bilinx.
•
A check mark under a camera number indicates that Bilinx control
is enabled.
•
Press a camera key on the unit to enabled or disable Bilinx control
for that camera.
•
By default all cameras are enabled.
•
If Bilinx cameras are looped-through to multiple Divars, only
one Divar is allowed to have Bilinx enabled!
>> SEQUENCES
The sequence in which cameras are displayed on monitor A and monitor B is set
in the full screen list menu.
•
Set the length of time each image remains on the screen by filling in the
dwell time value for each monitor.
•
Dwell time can vary from 1 to 60 seconds. The default value is 5 seconds.
>>> List Full screen monitor A
•
The sequence list shows the order in which the camera images are
displayed in full screen mode (Control Center version 1 only).
•
Use the arrow keys to select a position in the list. Press a camera key
on the unit to enter a camera number in the list.
•
Press F2 to clear the rest of the list.
•
Press F1 to restore all defaults. Connected cameras are then listed in
ascending order.
>>> List Full screen monitor B
•
The sequence list shows the order in which the camera images are
displayed in full screen mode (Control Center version 1 only).
•
Use the arrow keys to select a position in the list. Press a camera key
on the unit to enter a camera number in the list.
•
Press F2 to clear the rest of the list.
•
Press F1 to restore all defaults. Connected cameras are then listed in
ascending order.
>> CONFIGURE MONITORS
•
To view camera names, and time and date on a monitor set these items to
On
.
•
Set Motion Display to On to draw attention to any motion that occurs in
the designated zones.
•
Select the position for the text (top or bottom and fine position +11/-11).
Select text intensity. Select the border intensity of the cameos from four
values.
•
To automatically close the menu when an alarm or event occurs, set the
Exit Menu on Alarms
item to Yes.
•
The menu is closed after five minutes if you set the Menu Time-out to
On
.