Bosch Divar -Digital Versatile Recorder User Manual
Page 57
Bosch Security Systems
Divar | Installation Manual | Menu system
EN | 5-15
>>> Output handling
•
Select the profile for which you wish to configure the output
handling.
•
Select the number of the output relays to be activated when an
enabled event in the selected profile is activated.
•
Enable the beeper to activate it when an enabled event in the
selected profile is activated.
>>> Recording setup
•
Recording behavior for each of the six profiles is specified in three
submenus. The Normal submenu is for a normal situation without
alarms or motion events. The Input submenu is for input changes.
The Motion submenu is for motion events.
•
The list gives an overview of inputs and motions that are used in
any of the profiles. A check mark means used.
Normal
•
Select the profile. The Unallocated IPS item shows the IPS
capacity remaining.
•
A total of 60 images per second (IPS) can be recorded for NTSC;
50 IPS for PAL. A minimum of 1 IPS is always allocated per
camera for pre-alarm recording and network viewing.
•
Set the recording rates and quality levels for each camera. Quality is
standard, medium or high.
•
IPS rates for PAL range from Never, 0, 1/10 (one image every 10
seconds), up to 25 IPS.
•
IPS rates for NTSC range from Never, 0, 1/10 (one image every 10
seconds), up to 30 IPS.
•
Set the recording speed to NEVER to not record a camera at all.
No pre-alarm recording is done and the camera cannot be viewed
over the network. No ATM/POS data is recorded.
Input
•
Each input, when activated, can change the normal recording
behavior of up to four cameras for a maximum of 120 seconds.
•
Select the profile. Select the input number.
•
Select the cameras whose recording behavior should change. Set
the recording rates and quality levels for each camera. Set camera
name to None to use less than four cameras.
•
To free IPS bandwidth, the recording rate of cameras not in alarm
is limited to the IPS number displayed.
Motion
•
Each motion input, when activated, can change the normal
recording behavior of up to four cameras for a maximum of 120
seconds.
•
Select the profile. Select the motion camera number.
•
Select the cameras whose recording behavior should change. Set
the recording rates and quality levels for each camera. Set camera
name to None to use less than four cameras.
•
To free IPS bandwidth, the recording rate of cameras not in alarm
is limited to the IPS number displayed.
>>> Access restrictions
•
Remote access restrictions can be set for each of the six profiles.
•
Select the profile. Select if local playback is enabled or not.
•
Select which remote users have access and which are blocked.
•
Remote user 1, the administrator, always has access.
>>> Copy system behavior
•
To copy the settings of one profile to another, enter the number of
the source profile, enter the number of the destination profile and
select the Copy Now item.