Eberspacher EasyStart Remote - Manual (Page 15)

VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn | 15
5 WhAT TO DO iF …?
in the eVent Of a fault the fOllOwing flashing signals are pOssible:
LeD inDiCATOR pOssibLe CAuses ReMeDy / CusTOMeR
On pressing the or
button, slow red-
flashing 5x
Fault heater. Visit your vehicle workshop.
The easystart Remote has been
disconnected from the power
supply and then reconnected. Teach mobile unit as described in
the installation instruction.
Wait until the automatic detection
has finished.
After pressing the
or button, fast red-
green flashing 12x
(Communication is not
possible between the
mobile unit and station-
ary unit.)
Distance between mobile unit
and vehicle too large. Reduce distance.
Dense buildings between the
mobile unit and vehicle. Change the position relative to
the vehicle e.g. hold mobile unit
higher or move it to the side.
Reduce distance from vehicle.
several radio remote controls
are being used simultaneously. Reactivate the mobile unit after
a pause.
Mobile unit has not been taught. Teach mobile unit as described in
the installation instruction.
please nOte!
The unit cannot be used during the “redgreenflashing” signal. A switched on heater can only
be switched off using the button in the vehicle.
LeD flashes quickly
(flickers) green (6 sec-
onds) stationary unit is in learn mode. Teach mobile unit as described in
the installation instruction.
Wait until the automatic detection
has finished.
LeD lights up red follow-
ing activation (4 seconds) The mobile unit's battery is too
weak. Data transmission is not
possible. Replace battery ( see page 14 ).