Eberspacher EasyStart Remote - Manual (Page 8)

8 | VehiCLe heATeRs – TeChniCAL DOCuMenTATiOn
3 OpeRATiOn AnD seTTing/ADjusTMenT
nOtes On OperatiOn and setting
ACTuATe The MObiLe uniT
each press of the button results in an action,
which is indicated by flashing.
The flashing indicator goes out automatically.
before each operation or setting, a connection
must be established between the mobile unit
and the stationary unit.
To do this, press the
button until the
LeD indicator lights up green permanently,
then release the button and continue with the
operation or setting (see
from page 9 ).
peRMAnenTLy ChAnge The OpeRATing TiMe
10, 20, 30, 40, 50 or 60 minutes can be set
as the operating time (factory setting is 30
minutes).
see from page 10 for adjustment.
DATA TRAnsMissiOn
ƒ During data transmission the LeD display is
permanently lit green.
ƒ During the data transmission it is not pos-
sible to make settings or adjustments.
please nOte!
if data transmission was not possible the LeD
indicator flashes 12x red / green.