ECOXGEAR IRD4000: Allegro - Manual (Page 13)

13
Step 3 - Connect to the wireless network
When the ESS-ID for the access point you want to connect to is displayed on the screen, press OK.
IF your network is not configured to require an encryption code, the screen should display:
Connecting to
Network
then:
Network OK
IF the screen displays either WEP or WPA, a password is required:
Enter WEP key
OR
Enter WPA key
Then the network is using one of the encryption systems: Wired Equivalent Privacy (WEP) or WiFi
Protected Access (WPA or WPA2). You therefore need to enter the correct WEP or WPA password on
your ALLEGRO radio to communicate with your network.
Only the person who set up the network in the first place knows this password; if that person is not you
then you need to find out the password. You can do this by checking with the Customer Service of your
internet provider or the manufacturer of your wireless router.
After approximately 3 seconds, the display goes into the password entry mode:
<END ◄ ► A BCDEF>
█
To enter the password, use the SCROLL KNOB or the UP/DOWN buttons to select each
letter/number/symbol of the password in turn, pressing OK after each letter.