Enerpac S-Series User Manual

Page 10

Advertising
background image

10

ENGLISH

4.3.1 To tighten a nut or bolt (fig. G)
•

Position the tool on the nut or bolt in
the orientation as shown.

•

Operate the pump until the nut or bolt
has been tightened to the required
torque.

4.3.2 To loosen a nut or bolt (fig. H)
•

Apply releasing oil to the threads.
Allow the oil to soak.

•

Position the tool on the nut or bolt in
the orientation as shown.

•

Operate the pump until the nut or bolt
is loose.

If the nut or bolt will be re-used avoid
excess load when loosening.

-

Be aware that when loosening a nut
or bolt more torque is usually required
than when tightening.

-

Humidity corrosion (rust) requires up
to twice the torque required for
tightening.

-

Sea water and chemical corrosion
requires up to two and a half times
the torque required for tightening.

-

Heat corrosion requires up to three
times the torque required for
tightening.

Be aware that when loosening a nut
or bolt shock loading can occur. Do
not apply more than 75% of the
wrench’s maximum torque when
loosening nuts or bolts.

Fig. H

Fig. G

Advertising