Enerpac S-Series - Manual (Page 7)

ENGLISH
7
Fig. C
3.4 To fit and remove a hex socket
(fig. C)
3.4.1 To fit a hex socket
•
Position the socket (9) onto the drive
shaft (1).
• Fit the retaining pin (10).
3.4.2 To remove a hex socket
•
Remove the retaining pin (10).
• Take the socket (9) off the drive shaft
(1).
3.5 To mount the reaction arm (fig. D)
The reaction arm can be rotated
incrementally through 90˚, which will
maintain stability against a reaction point
up to full torque.
•
Position the reaction arm (6) onto the
ratchet end (11) of the tool.
• Press the latch (7) and slide the arm
all the way onto the tool. Release the
latch to secure the arm.
• To adjust the angle of the reaction
arm (6), press the latch (7) and slide
the arm off the tool. Position the arm
as necessary.
Fig. D
1
10
9
11 7 6