ETC Eos Titanium, Eos, and Gio v2.0.0 - Manual (Page 418)

400 Eos Titanium, Eos, and Gio Operations Manual
Remote Processor Unit 3 (RPU3)
Hardware Setup
Rear Panel
Step 1: Attach the IEC power cord to the power connector.
Step 2: Connect any monitors to the proper ports on the back of the RPU.
Step 3: Connect the mouse and keyboard to the USB connectors.
Step 4: Attach a network ethernet cable to an ethernet port.
Step 5: Once all accessories have been connected, you may activate the hard power switch
on the rear panel.
N o t e : The Eos RPU 3 can support up to three monitors. The connectors are DVI-I.
The minimum screen resolution is 1280x1024.
Hard Power
Switch
IEC Power
Connector
DVI-I Video
Ports
USB 2.0 ports
Ethernet
Ports 1 & 2
Audio Ports
(Not Currently Enabled)
DMX x2
Phone
Remote
Remote
Trigger
Midi In
& Out