ETC Source Four HID - Manual

Source Four™ HID • 1
Source Four ™ HID
Lamp type and general information:
Do not use lamps other than the following lamp type in Source Four HID fixtures. Use of lamps other
than specified below will void UL/cUL safety compliance and your warranty .
• Source Four HID is suitable for damp locations
• Can be canopy mounted
• No recessed mounting
Caution! Source Four HID is NOT dimmable. Dimming will damage ballast and void warranty.
Ballast information
Caution! The Source Four HID cannot be dimmed.
• Acceptable voltage is 120V (+/- 10%) 50/60HZ only .
• Operating current of 1.5 Amps
• Inrush current of <14 Amps
• Room ambient temperature should not exceed 104ºF (40ºC)
• Lamp ignition voltage is 4.5Kv, non-hot restrike.
• Ballast case temperature should not exceed 167ºF (75ºC)
• The ballast is attached to the Source Four yoke by two screws, non-remotable.
Lamp Type Manufacturing Codes Watts Base Bulb LCL Ave.
Hrs.
Initial
lumens
Color
temp
Ceramic Metal Halide
CDM-T 150W/830 150 G12 T6 56mm 9000 14000 3000˚K
CDM-T 150W/942 150 G12 T6 56mm 9000 12700 4000˚K
MD150T6/U/G12/830 150 G12 T6 56mm 9000 14000 3000˚K
MBI150/T/30 150 G12 T7 57mm 6000 11500 3000˚K
MBI150/T/40 150 G12 T7 57mm 6000 11250 4000˚K
Table 1: HID lamp reference
Beam focus knob
Lens tube
Shutters
Barrel
Pattern holder slot
Retainer bolt
Drop-in iris
Retaining clip
Color frame
Color frame holder
Reflector housing
Yoke locking knob
Lamp housing
Ballast
Barrel rotation knob
Yoke