EUCHNER MGB-LxxB-PNA-xxx (PROFINET) with Data Structure Type A - Manual (Page 15)

Operating Instructions Safety System MGB-L..B-PNA-... (PROFINET)
15
Important!
The following applies to systems with guard locking: The system enters into a
latching fault when the escape release is actuated. See System status table on
page 31, status Signal sequence erroneous (DIA1 flashes 7 times).
The system might not enter into a latching fault if the escape release is actuated
very slowly.
Preparation of the escape release
1 Fit door handle
2 Insert actuation axis. The locking ring A must be in contact with
the escape release B
3 Tighten setscrew to 2 Nm
4 Fit protective sleeve
Figure 8: Preparing escape release
1
3
2
4
A
B
58
,5
4
D
4
(10)
55
,5
250
182
D + 13,5
3,5
D + 3
Example with mounting plates:
Actuation axis
Protective sleeve
Mounting
plates
(+ 4 mm per plate)
(+ 4 mm per plate)