Euramco Safety VX700 - Manual (Page 17)

8.0 Operation
8.2 Run Procedure, (Continued)
8.2.1 Start-Up
9. Lift red safety cap and toggle the Emergency Stop switch to the "ON"
position.
10. Rotate the Fuel Valve to the "ON" position.
11. Pull choke knob out on GX630 Honda Engine control panel.
12. Set motor throttle to idle / low speed.
13. Insert ignition key into the motor's ignition switch.
14. Turn ignition switch clockwise until the engine turns over and starts to run on
its own.
Note: If this is the first time the motor has been started it may take 15 to 20
seconds before the fuel pump can transfer enough fuel to the motor's
carburetor before the motor fires-off.
15. Slowly push the choke knob in after motor starts to run.
16. If motor dies when choke is pushed in pull choke out and restart engine. Let
engine run a bit longer before choke is pushed-in.
17. Adjust the tilt angle as desired to point air stream into building.
Note: The Honda GX630 motor has an oil level alert function that kill the
motor when the motor is tilted more than 20
˚. The combined tilt of the
vehicle plus the tilt of the fan must not exceed 20
˚.
18. Adjust the motor throttle for the amount of air needed for the application.
19. Turn Water Valve "ON" to start-up the mister nozzles.
Page 16