Software settings – EZWatch EZBR-0519HD User Manual
Page 4
4
through the bottom cover and plug into the RJ45 Jack inside the unit.
Keep the black gasket material in the bottom of the cover to help keep
out dust and insects.
STEP 6: Route shielded CAT5 cable from the antenna into the building.
Always create a strain relief near the antenna so the cable is not pulling
directly on the antenna. Use the CAT5 strain relief hook feature built
into the housing back fin. The
Ethernet spec allows for a maxi-
mum cable length of 100 meters or
about 328 feet.
STEP 7: Install a CAT5 cable be-
tween the POE Inserter input and
your router, switch or PC. Attach the
CAT5 cable from the antenna to the
RJ45 output port of the POE In-
serter. Plug the POE Inserter into a
surge protected AC power source to
power up the EZ-Bridge
™
Software Settings
We strongly recommend that you create a working plug
and play link before making ANY changes to the soft-
ware settings
1. There is an HTML management system built into every EZ-Bridge™
unit which is accessed thru a standard web browser. The unit can com-
municate thru the CAT5 ethernet cable connection or thru the wireless
connection, so you can manage remote units from a single location.
NOTE: The device will usually go into a 2minute reboot cycle When
clicking on APPLY CHANGES. During this time it will be unresponsive.
2. IP ADDRESS: Default IP addresses for the EZ-Bridge™ are
192.168.1.139 and 192.168.1.239. To access the EZ-Bridge™ your
computer IP address must be on the same subnet ie; 192.168.1.xxx.
TECH TIP: Download the EZ Discovery Tool from . This tool will assist you in finding the EZ-Bridge™
on the network and allow you to change the IP address or set it as a
DHCP client. Just select the unit, click on IP DETAILS, make selec-
tions, enter the user name and password and save changes directly to
the device.