Feiss MR1106 Mirror - Manual

Carefully unpack and identify all parts before assembly.
1. Lay glass mirror, with u-channels facing up, on a
non-abrasive and elevated surface.
2. Lay frame on top of glass mirror by aligning frame holding
rods into notches in u-channels. Make certain glass mirror
is centered within frame.
3. Lock holding rods into u-channel by attaching cover and
then fastening with machine screws (from inner-side of
u-channel) and lock washer and hex nut (from outer-side
of u-channel). See assembly detail graphic.
4. Hang all crystal glass parts as shown on drawing.
5. WALL MOUNTING: Requires two 30lbs. or over capacity
picture frame hangers or hooks (not included). Screws are
not recommended.
A. Decide desired wall location to hang mirror.
B. Install 2 picture frame hangers or hooks (not included)
on wall with approximately 14" distance to each other at
location corresponding with upper holding rod.
Assembly Instructions For
MR1106
Crystal Glass
(E) 5/10
Frame
Holding Rod
U-Channel
Glass Mirror
Extra PIN
Qty.
Required
Extra 1
X4 Head Pin
Small S- Hook
PIN
DESCRIPTION
X1
X1
PIN PART
U-channel
Lock Washer & Hex Nut
Machine Screws
Holding Rod
Assembly
Detail:
Cover